
MB-PULSE 4

The MB-PULSE 4 module allows the conversion of an impulse signal (REED or OC) into the Wired MBUS (EN13757-3) signal.
The device allows the connection of up to four meters equipped with pulse output (water, gas, electricity, heat etc.) of any brand, size and version.
Each record is distinguished by four separate addresses, allowing an easy reading of the consumption for each meter connected.
Easy to configure and install it gives the possibility to configure the primary addresses by using the B METERS software BMBUS and data concentrator mod. MB-MASTER.
The device allows the connection of up to four meters equipped with pulse output (water, gas, electricity, heat etc.) of any brand, size and version.
Each record is distinguished by four separate addresses, allowing an easy reading of the consumption for each meter connected.
Easy to configure and install it gives the possibility to configure the primary addresses by using the B METERS software BMBUS and data concentrator mod. MB-MASTER.

TECHNICAL FEATURES
DIMENSIONS | 89 x 74 x 40 mm |
WEIGHT | 122 g |
TEMPERATURE RANGE | +1° / +55°C |
POWER SUPPLY | From BUS Network, 3 V Lithium Battery (backup) |
BATTERY LIFE | 1 year (if disconnected from BUS network) |
PROTECTION CLASS | IP65 |
TRANSMISSION PROTOCOL | MBUS Standard EN 13757-3 |
MEASUREMENT SENSIBILITY | 1 – 10 – 100 – 1000 |
MEASUREMENT UNITS AVAILABLE | L – Wh - KJ |
TRANSMITTED DATA | Consumption Device Status |
INPUTS | N°4 pulse inputs. Connectable to pulse emitters (REED and Open Collector) |
MAXIMUM INPUT FREQUENCY | 20 Hz |
OUTPUT | N°1 Wired MBUS output |
WEIGHT AND DIMENSION

Example of installation